My 3d print work in progress
By - b3rdm4n
Hey, bud. Any way you can orient the noctua the other way around? I heard noctua said it will not be efficient in that orientation.
You've gone mad at 3d printing. Since nobody made this yet... can you design a front panel mesh so we can stick a fan in front?
The Noctua physically won't fit in this case in any other orientation, but yes it has been pointed out before and I tried.
I can take a look at the front panel, why not.
That screen is plugged into your gpu?
In that photo is has a chromecast plugged into the screen
What’s going on at the bottom? Looks like you made it taller. Not using an AIO...so what’s up? 🤔
Not OP, but yes.
Edit: oh wow, a chromecast? That’s cool. I’ve never seen that. I assumed it was like every other setup I’ve seen using hdmi to the gpu, my mistake.
How exactly is that CPU cooler supposed to exhaust anywhere? Also, that's a lot of combustible PLA you have here around parts that exceed 70/80c. I'd be a bit careful. It's not going to spontaneously combust, but it might deform a lot.
Yea if u actually vented the CPU’s air upwards instead of to the backside ull get better temps probably
If I could rotate the cooler 90 degrees I would, it doesn't fit any other way than what is pictured. The case design is highly effective at moving air though, this layout works very well as it is.
Awesome dude what’s the temps like
Gaming is high 55-65c, stress testing 73-75c. I suppose if I wanted to move into a 5000 series chip I'd probably want to rethink the cooling.